Fast Tracked Shipping On All U.S Orders

Peel and Stick Wood Slat Wall Panels

£62.46
Currently in stock 1 year warranty
Color: Light Wood
Pack: 1 Roll (15.7 x 118 in, 12.9 sq ft)
Secure checkout. We acceptAmerican Express Apple Pay BancontactDiners ClubDiscoverGoogle Pay KlarnaMaestroMastercard PayPalShop Pay Union PayVisa

Fast tracked U.S. shipping

Easy 30 day returns. Not quite right? Send it back for a full refund.

Frequently bought together

Pairs well with this

The Little Jax Slat Wall Roll

The Designer Slat Wall, Without the Carpenter

A wood slat accent wall is one of the easiest ways to make a room look expensive. Normally it means cutting and fixing dozens of wooden battens.

This comes as one self-adhesive roll, 15.7 inches wide and 118 inches long, so the slats run in one continuous line from floor to ceiling. Peel off the backing, line it up and press it on.

Light wood peel and stick slat wall panel being applied to a wall

Check this first

How Much Do I Need?

Each roll is 15.7 inches wide and 118 inches (9.8 ft) long, so you work out how many you need from the width of the wall. Measure the wall from side to side in inches and divide by 15.7, then round up.

Each roll covers a strip up to 9.8 ft tall, enough for floor to ceiling on a standard 8 or 9 ft wall. Trim the excess at the bottom with a utility knife.

Area Size You need
4 ft wide wall 48 in wide, up to 9.8 ft tall 4 rolls
6 ft wide wall 72 in wide, up to 9.8 ft tall 5 rolls
8 ft wide wall 96 in wide, up to 9.8 ft tall 7 rolls
10 ft wide wall 120 in wide, up to 9.8 ft tall 8 rolls
12 ft wide wall 144 in wide, up to 9.8 ft tall 10 rolls

Walls taller than 9.8 ft need extra rolls to finish the top section. Choose your number of rolls above.

Easy to install

Floor to Ceiling in an Afternoon

No saw, no nails and no adhesive to mix. One person can do a feature wall, and two makes the long drops easier.

1Clean the wall and mark a straight vertical line with a level, so your first roll goes on dead straight.
2Peel back the top of the liner, line the roll up with your mark at the ceiling and press it on.
3Work downwards, peeling the liner as you go and smoothing from the center out to push out air.
4Butt the next roll tight against the first so the slats line up, then trim the bottom with a sharp knife.

Before you start: the wall must be smooth, clean, dry and free of grease. Freshly painted walls need at least 3 to 4 weeks to fully cure first.

Where it works

The Right Spot for Peel and Stick

It suits living spaces where you want warmth and texture on a flat, smooth wall.

Great for

  • Living room and TV feature walls
  • Behind the bed as a headboard wall
  • Home offices and video call backdrops
  • Hallways, entryways and stair walls
  • Smooth painted drywall with a satin or eggshell finish

Not suitable for

  • Directly behind a stove, hob or fireplace
  • Textured, bumpy or popcorn walls
  • Damp walls or inside a shower
  • Flat matte or freshly painted walls
  • Ceilings

Heat safety: this is a PVC and vinyl product, and it can warp or melt near high heat. Do not install it directly behind a gas hob or cooktop, around a fireplace or near any open flame. Behind the stove, keep ceramic tile, glass or stainless steel.

The details

Specifications

Roll size 15.7 x 118 in (1.3 x 9.8 ft)
Coverage per roll 12.9 sq ft
Material Self-adhesive PVC foam with wood grain finish
Finish Vertical slat grooves with printed wood grain
Moisture Water and moisture resistant, wipe clean
Cutting Cuts with a utility knife or scissors
Colors Light Wood, Brown, Dark Wood, White, Light Gray, Dark Gray
Light WoodBrownDark WoodWhiteLight GrayDark Gray

Good to know

Frequently Asked Questions

Q

How many rolls do I need?

Measure your wall from side to side in inches and divide by 15.7, then round up. A 10 ft wide wall takes 8 rolls. Each roll runs 9.8 ft top to bottom.

Q

Is it real wood?

No. It is a lightweight PVC foam panel with a wood grain finish and slat grooves, which is what makes it light enough to stick straight onto the wall.

Q

Will the joins between rolls show?

The rolls meet along a slat line, so when they are butted tight together the join sits in a groove and blends into the pattern.

Q

Can I cut it around outlets and switches?

Yes. Turn off the power, remove the cover plate, stick the panel over the opening, cut it out with a sharp utility knife and refit the cover plate.

Q

Can I use it on a textured wall?

It needs a smooth wall. On textured, bumpy or popcorn finishes the adhesive cannot grip properly and the panel may lift.

Q

Can it go behind my stove?

No. Do not install it directly behind a gas hob or cooktop, around a fireplace or near open flame. PVC and vinyl can warp or melt with heat. Use it on the rest of the backsplash and keep ceramic tile, glass or stainless steel behind the stove.

Q

Can I take it down later?

It is made to stay up. On painted drywall, taking it down can lift paint or the paper face of the wall, so plan for some touch-up work if you ever remove it.

Q

Why should I buy all my packs at once?

Colors can vary slightly between production batches. Ordering everything together keeps the whole wall matching, and it is worth adding about 10% extra for cuts and edges.

Give Any Room a Designer Feature Wall

Choose your color and number of rolls above.

Reviews

Fast US deliveryOn all U.S. orders
Secure checkoutEncrypted and protected
30 day returnsShop with confidence
Quality checkedHand picked pieces
Peel and Stick Wood Slat Wall Panels
£62.46
logo-paypal paypal